![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/tinker.png)
First Step
Open TinkerCode app in your browser
Click here to go to TinkerCode app!
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/1-lm35-1.png)
Second Step
Drop setup block and adruino loop from Base Controller menu
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/3-lm35.png)
Third Step
Add variable and create variables name
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/4-lm35.png)
Fourth Step
Drag the temperature block and put at the base block.
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/5-lm35.png)
Fifth Step
Go to Robotkit and choose Makerkit Nano.
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/6-lm35-1.png)
Sixth Step
Drop temperature sensor in empty block
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/7-lm35.png)
Seventh Step
Choose specified pin number and set variable as number then, display the result
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/8-lm35.png)
Eight Step
Replace with temperature block
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/9-lm35.png)
Ninth Step
Connect Maker Kit Nano to your PC/laptop using USB cable
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/10-lm35.png)
Tenth Step
Set board type and port
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/11-lm35.png)
Eleventh Step
Upload the code and wait until finish uploading
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/12-lm35.png)
Final Step
Select serial dashboard to see the result
![](https://thinkerspace.my/makerkit/wp-content/uploads/2021/03/13-lm35.png)
The result
The temperature is showing up!